flexiblefullpage
billboard
interstitial1
catfish1
Currently Reading

How to prevent corrosion in sprinkler system piping

Codes and Standards

How to prevent corrosion in sprinkler system piping

The technical committees responsible for NFPA 13, Installation of Sprinkler Systems, have been looking at ways to eliminate or reduce corrosion in sprinkler systems for several revision cycles.


By Peter Fabris, Contributing Editor | June 18, 2015
How to prevent corrosion in sprinkler system piping

Image: Pixabay

Corrosion in sprinkler system piping can be a costly problem if leaks occur, causing damage to the interior of a structure, according to Matt Klaus, Principal Fire Protection Engineer with the National Fire Protection Association. 

Replacing piping is no small expense, either. Corrosion can also cause blockages in the piping network, which can lead to an ineffective sprinkler system during a fire.

Corrosion can take on many forms, including oxidation, microbiologically influenced corrosion, and galvanic corrosion. The technical committees responsible for NFPA 13, Installation of Sprinkler Systems, have been looking at ways to eliminate or reduce corrosion in sprinkler systems for several revision cycles.

Reducing corrosion in dry systems can be achieved by eliminating all of the water from these systems after testing/activation and using alternative gases like nitrogen for charging these systems. For wet systems, limiting the amount of air in the system is the goal. Air trapped in pressurized sprinkler system piping results in an increase in the concentration of dissolved oxygen in the piping, enabling corrosion. Venting the trapped air in a wet system reduces this problem, so a revision to the wet system sprinkler system standard requires that a single air vent be installed for each system.

Depending upon the building geometry and sprinkler design, it is possible to trap air in many locations in the system, meaning a single vent may not be effective. Therefore, some stakeholders believe that the requirement adds cost to the property owner and the design team without any assurance that there is a long-term benefit to the system.

More tips and advice from the NFPA.

Related Stories

Codes and Standards | Jul 27, 2021

Add a wobbly moon to flooding risk factors

Earth satellite’s orbit variations will lead to sunny-day flooding in the mid-2030s.

Codes and Standards | Jul 26, 2021

Revamping of Florida building codes on the table after condo collapse

Tragedy could prompt upgrades like post-Hurricane Andrew effort.

Codes and Standards | Jul 21, 2021

Proposal to give Calif. hospitals more time for earthquake retrofits stirs controversy

State hospital association says 2030 deadline should be extended.

Codes and Standards | Jul 20, 2021

New York, New Jersey legislatures may revamp bidding rules to promote low-carbon concrete

Contractors would have to certify that their concrete is in compliance.

Codes and Standards | Jul 19, 2021

Lack of information on carbon emissions challenges construction industry

Reports recommends whole-life carbon assessments on building projects.

Codes and Standards | Jul 15, 2021

Three drywall code-referenced publications have been updated

Include guidance on fire resistance, sound control, application, and finishing.

Codes and Standards | Jul 14, 2021

Biden’s infrastructure proposal includes massive investment in school buildings

‘Once in a lifetime opportunity’ to upgrade HVAC and other key systems.

Codes and Standards | Jul 13, 2021

Reluctance to fund maintenance on older condos is a serious problem

Owner associations defer needed work, putting properties at risk.

Codes and Standards | Jul 12, 2021

Regulations on hydrofluorocarbons reduce roof insulation options

Canada, some U.S. states ban HFC blowing agents used in closed-cell foam.

boombox1
boombox2
native1

More In Category




halfpage1

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021