Culver Cove is an 80‑unit condo complex located on Lake Maxinkuckee near Culver, Ind.
Originally hot water was supplied from three strategically located utility rooms, each with six 100‑gallon commercial tank‑type heaters. Circulating pumps and mixing valves were required to prevent scalding. Rich West, Executive Director of Culver Cove, was looking for a more efficient hot water system to reduce energy costs, especially during low demand periods. His research led him to the Navien Premium Efficiency (NPE) tankless water heaters that would eliminate the energy cost of constantly running the tanks to be ready for hot water demand.
West worked with Mike Lambert, then with Mid-City Supply Co., and Clark Boyles of P-M & Associates, the Navien distributor and rep in northern Indiana. They recommended a phase one installation of five cascaded Navien NPE-240A units for about one-third of the complex—about 26 units, from one to three bedrooms each. With the proven energy savings of the first phase, Culver Cove proceeded to change out the other two utility rooms that served the rest of the condos.
Culver Cove, an 80-unit condo community in Culver, Ind., installed Navien tankless water heaters to improve its overall energy efficiency.
Lambert and Boyles worked with Jason Richards, Owner of A+ Plumbing Heating and Cooling, to work out details for sizing, designing, and installing the system. The installation of each section took about a week and a half, including removing the old tanks. The five Navien units used two sets of four-inch PVC vent pipes that ran through the roof in an existing 12‑inch B vent.
BENEFITS OF NAVIEN NPE TANKLESS SYSTEM
Efficient hot water supply. “The five Navien units are cascaded so when the master unit comes on, it triggers the next one in line to help as needed, and so on until all units are running if necessary,” said Richards. “Each time a Navien unit comes on, it’s a different master-slave situation, so all five units have equal run times.”
Technical factors. “Unlike the old tank system, we could eliminate the external circulating pump and mixing valve, since we can set the temperature at 120 degrees,” said Boyles. Another factor in selecting Navien NPE-A tankless water heaters was the internal recirculating pump and buffer tank, which assure an uninterrupted flow of hot water.
Old conventional water heaters at Culver Cove condominiums were replaced to improve energy efficiency.
Energy and water savings. “We have noticed a decrease in our energy cost from NIPSCO, our local gas supplier—a real dollar savings every month,” said West. “We have applied for an energy rebate. I also have seen a decrease in our domestic water use.”
Easier installation. “One of the main reasons we went with Navien is the ability to use PVC,” Richards said. “The common venting also makes it less expensive. In this retrofit situation, we could use existing penetrations to run our vents. That saved a lot of labor.”
For more information: NavienInc.com.
Related Stories
75 Top Building Products | Apr 22, 2024
Enter today! BD+C's 75 Top Building Products for 2024
BD+C editors are now accepting submissions for the annual 75 Top Building Products awards. The winners will be featured in the November/December 2024 issue of Building Design+Construction.
Plumbing | Mar 18, 2024
EPA to revise criteria for WaterSense faucets and faucet accessories
The U.S. Environmental Protection Agency (EPA) plans to revise its criteria for faucets and faucet accessories to earn the WaterSense label. The specification launched in 2007; since then, most faucets now sold in the U.S. meet or exceed the current WaterSense maximum flow rate of 1.5 gallons per minute (gpm).
75 Top Building Products | Dec 13, 2023
75 top building products for 2023
From a bladeless rooftop wind energy system, to a troffer light fixture with built-in continuous visible light disinfection, innovation is plentiful in Building Design+Construction's annual 75 Top Products report.
Codes | Jul 10, 2023
Water Demand Calculator outperforms traditional plumbing codes for energy, carbon, and water savings
Using IAPMO’s Water Demand Calculator tool can result in energy, carbon, and water savings as compared to using traditional plumbing specification methods in plumbing codes, according to a study by Arup.
Arenas | Jun 14, 2023
How Seattle’s Climate Pledge Arena is conserving water
More than 700 water closets, urinals, flushometers, and faucets combine to save water at the 18,300-person Climate Pledge Arena, in Seattle.
Plumbing | Jun 1, 2023
Olympia debuts a single-handle faucet for i4 Series for the bath
Olympia Faucets has introduced a new single-handle lavatory faucet (Model #L-6000) to its popular i4 series.
Codes | Mar 2, 2023
Biden Administration’s proposed building materials rules increase domestic requirements
The Biden Administration’s proposal on building materials rules used on federal construction and federally funded state and local buildings would significantly boost the made-in-America mandate. In the past, products could qualify as domestically made if at least 55% of the value of their components were from the U.S.
75 Top Building Products | Nov 30, 2022
75 top building products for 2022
Each year, the Building Design+Construction editorial team evaluates the vast universe of new and updated products, materials, and systems for the U.S. building design and construction market. The best-of-the-best products make up our annual 75 Top Products report.
Engineers | Nov 10, 2022
U.S. engineering firms cash in on a volatile, expanding market
New practices and markets drive growth for U.S. engineering and engineering-architecture firms. And firms are getting serious about reducing projects’ carbon footprint.
Building Materials | Nov 2, 2022
Design for Freedom: Ending slavery and child labor in the global building materials sector
Sharon Prince, Founder and CEO of Grace Farms and Design for Freedom, discusses DFF's report on slavery and enforced child labor in building products and materials.